Free Download CCIE Routing and Switching Exam Question


  •     SPOTO
  • |
  •   Posted on: 2019-04-30
  • |
  •   Views: 288
  • |
  •   Category:
  • CCIE Written

Exam Pre-Configuration Instructions

1) The interface IP/IPv6 addresses have been configured

2) Some switches have been configured the VLAN information,there is one switch needs configure VLAN yourself, please check the pre-configurations.

3) The addresses information will note on the topologies, please check them with pre-configurations.

4) There is this command on R2 BGP VRF INET: network 123.2.2.2 mask 255.255.255.255, delete it.

 

 

If R2’s loopback0 was associated in VRF INET, move the interface to global and reconfigure IP address.

 

SECTION 1 Layer 2 Technologies

Section 1.1 VTP

Configure the ACME Headquarters network (AS 12345) as per the following requirements:

l the vtp domain must be set to CCIE

l use vtp version 2

l sw1 must be the vtp server and sw2 must be the vtp client

l secure all vtp updates with an MD5 digest of the ASCII string CCIErocks$

l in order to avoid as much as possible unknown unicast flooding in all vlans the administrator requires that any dynamic entries learned by other sw1 and sw2 must be retained for 2 hours before being refreshed.

Please pay attention to view the password on the exam

 

 

Solution:

SW1

vtp domain CCIE

vtp version 2

vtp mode server

vtp password CCIErocks$

 

SW2

vtp domain CCIE

vtp version 2

vtp mode client

vtp password CCIErocks$

 

SW1/SW2

mac address-table aging-time 7200

 

 

Configure the network of the new york office (AS 34567) as per the following requirements

l the vtp domain must be set to CCIE

l use vtp version 2

l sw3 and sw4 must not advertise their vlan config but must forward vtp
advertisement that they receive out their trunk ports

l secure all vtp updates with an MD5 digest of the ASCII strings CCIErocks$

 

 

 

 

Solution:

SW3/SW4

vtp domain CCIE

vtp version 2

vtp mode transparent

vtp password CCIErocks$

 

 

Comments:


Start the discussion...


To Leave a Comment or reply to posts please log in