Finally Pass My CCIE Security Lab Exam


  •     SPOTO
  • |
  •   Posted on: 2019-04-16
  • |
  •   Views: 210
  • |
  •   Category:
  • CCIE Lab

I have to thanks my friend, without him i won't choose spoto, or buy lab materials from SPOTO. Same as many members in the form, i was confused about which materials are deserve to buy. My friend mohanmd recommend me to try spoto dumps, cuz he pass his ccie rs 400-101 with spoto dump. 

Tutors are kind to every question i raised. i will show part of our dialogue

me,13:06
I have another question regarding task 5.2 wireless 

it is require to configure the AP however I did not see any command to save the configuration.  In the workbook only specifies how to configure it  and clear the config.

do you know how to save it ?


tutor,13:11
don't have to save,  just configure and make sure it can registered to wlc


me,13:12
OK thanks!

tutor,9:47
yep, we noticed that will try to solve it


me,9:49
no problem

I just want to make sure the issue is not with the configuration


me,10:07

in TS3 I tried several thing to sync the router with the WSA but it did not work 

reboot WSA,, reset the wsa and reboot the router

is there any known issue ?


tutor,10:26
Try it a few more times

tutor,13:50

check the DNS

on GUI

me,13:51
it is 150.1.7.100

but the WSA is not able to reach it


tutor,13:52
reboot wsa or re-initialize


me,13:52
ok

me,6:28
(Rack01, Physical)

tutor,9:37

follow the instruction for rac.pdf

me,9:45
ok!do you know which TS is the most common or less common ?


tutor,9:49
well, all is common in Richardson

so, just focus on preparation


tutor,11:36
good day bro

due to your exam is coming soon, so if there is anything you don't understand, just ask right here

or we can check your lab when you done, it should be better to solve some potential problems


me,12:15
do you have a list of potential problems ?  besides the information listed in the document: pay attention


tutor,12:44
nope, it's up to you, we just check and find out


me,10:10

in TS3+ you add a route for ClientPC  however in the incidents it does not mention to redirect the traffic to WSA for clientpc, it only mentions anyconnect pc


tutor,10:26
yep, you're right

maybe there is something wrong

and just igonre the wrong route


tutor,13:13
TS++

MAB command is not add it in the solution

I guess this is a mistake and we need to add the MAB command

 

My CCIE Security Lab exam combo: TS DIAG1, CFG

TS:
TS1 same as SPOTO

DIAG:
DIAG1 same as SPOTO

CFG:
I  couldnt  select  the  groups  under  profiled like  cisco  ip  phone  group,  etc  was  not  showing
I  created  my  own  groups,  and  did  authorization  rule  with  those

Thanks bro in SPOTO CLUB members, SPOTO service and tutor help me pass my exam at first try.

Comments:


Start the discussion...


To Leave a Comment or reply to posts please log in